20x Resin 3d Printer Tank Cleaning Tool - Clean off the FEP/Release Film in Your Vat FAST - Mars Saturn Jupitor Photon Mono Halot Mage One Sonic Mini Mighty Mega (20pc)

• Easily clean the bottom of the resin tank on your resin 3d printer

• Lock-on bottom texture to hold tight to resin sheet

• Get back to printing FAST!

• Mess-free removal of cured sheet after running a cleaning cycle on your machine

Clean your resin 3D printer's tank/vat quickly and easily so you can get back to printing FAST. Place 1 or 2 of these near the corner of your vat, but in an area covered by the LCD screen underneath. Be sure that there is no solid material between the tool and the release film at the bottom. Then run a cleaning cycle on your machine. This will cure a sheet of resin, along with anything that needs removed, to the tool, allowing you to easily peel it up and remove it to get your machine back to work. Print failures are inevitable, and when it happens removing the junk stuck on the bottom of the resin tank can be a time-consuming and often messy process. Put an end to that headache. Happy printing.